E-36RECORDING – Setting time codes –This unit has a built-in time code reader/ generator. It records time codes during recording. Itdoes not record the user’s bit.Time codes are recorded according to the recording condition as follows:Time codes are recorded in the REC RUN mode. (REC RUN: time codes run only duringrecording.)Time code recordingTime codes are preset via the TIME CODE menu. It can beset via either the remote controller or the Main unit. Press the OPERATE button on the Main unit or theremote controller to turn on the power and set theunit to the STOP mode.* To set it with the main unit, first remove the cassette from theunit if it is loaded.Condition Time code recordingTime code is preset with this unit.Time code is not preset.Preset time codes.SETMENIUEJECTREC PLAY PAUSEREW STOP FFDVCAM NTSC PAL REC INH.CH-1/3CH-2/4BR-DV3000BSEL.EY/CPLAY buttonEJECT buttonPAUSE buttonFF buttonSTOP buttonREW buttonDISPLAYBARSMENU SEARCH+SEARCH–SETBLANKSTILLMODEAUDIOMUTINGOUT SEL.OUT LEV.MENUbuttonbuttonbuttonbuttonbuttonSET button• Time codes preset in the built-in time code generator are re-corded. (First time only)• When recording ends, the set time codes becomes void andregeneration occurs.MemoThe framing mode is selected from the NDF/DF item of the TIMECODE menu. (NTSC only)• It reads the time codes recorded on the tape and continuesrecording time codes from these values. (Regeneration)• If no time code is recorded, it starts from “00”.* Sometimes, the time codes recorded at the beginning of thetape may not be read.MemoWhen the REC button is helddown in the STOP mode, thevalue of the built-in time codegenerator is displayed.
