E-39RecordingRecording with the Front PanelOn a DVD, the section of video recorded between the start of recording and pressing of the STOP button to end recording isstored as a single title, and a unique title number is assigned to each of these sections. A single disc can contain up to 99 differenttitles.In addition, each title can be separated into a number of different chapters by inserting chapter marks at the appropriate points,and each title can contain up to 99 chapters.Information relating to titles and chapters is stored on a disc in the form of title and chapter menus. When the disc is being played,therefore, the title and chapter menus can be used to access specific sections of stored video and audio. Insert a disc that can be recorded on.1. With the DVD recorder stopped, make all of the required settings andadjust the audio recording levels.2. Start recording.This is done by pressing the REC and PLAY buttons simultaneously.3. Pause recording.This is done by pressing the PAUSE button.• The recording pause mode is entered.When the AUTO CHAPTER (REC PAUSE) item of the RECORDER [1/2]screen is set to ON, a chapter mark is automatically inserted when therecording pause mode is entered.A number of different methods can also be used for the manual or auto-matic insertion of chapter marks. (X Page 40)4. Restart recording.Press the PLAY or PAUSE button.• Recording will begin once again and a new chapter will be created in thecurrent title.5. End recording (i.e., close the title)Press the STOP button when either recording or paused.• The action of the DVD recorder following the end of recording depends onthe setting of EDIT MENU from the DVD MENU screen.DISABLE : Recording is ended and the chapter menu is created using pre-set settings (i.e., the title is closed).ENABLE : The THUMBNAIL EDIT screen will appear. This screen can beused to modify the chapter menu’s display style, to change thethumbnails used, to input chapter names, and to perform othersimilar functions. For more details, refer to Page 48. If additional recording is to be carried out, repeat steps 1 through 5above.• In such a case, the subsequent recording is stored as a new title.LCD displayOPEN/CLOSE buttonSTOP buttonPAUSE buttonREC button000 min04/05/0611:20:00TITLE 01 0:11:22CHAPTER 01 0:11:22RECNotes• A maximum of 10 minutes will berequired to complete title closing.• The remaining time available for record-ing on a disc will be displayed on themonitor. Note that this is to be used as ageneral guide, not as an exact figure.(DISPLAY and REMAIN from the DIS-PLAY MENU screen must both be ONfor this figure to be displayed.)• During the recording process, the cur-rent title number and chapter numberare displayed on the monitor.(ONSCREEN will be displayed when theDISPLAY item is ON and the TITLE/CHAPTER/INDEX item is set toTITLE+CHAPTER.)Remaining timeMonitor displayTitle and chapter numbers
