JVC 1204MNH-SW-VE Instructions Manual

Contents

18 EN INITIAL SETTINGSAuto Channel Set by Downloading from TV/Auto ClockSet/Auto Guide Programme Number SetIf you have connected the unit to your TV via a 21-pin SCARTcable (A pg. 16), the unit will automatically perform PresetDownload instead of the Auto Set Up in step 4 on page 17. Afterdownloading, the unit sets the clock and Guide Programmenumbers automatically.1 Press D E to select AT-V LINKBand press ENTER. The T-VLINK screen will appear.● When T-V LINK is completed,ASCAN COMPLETEDB appearson the TV screen. After selectingAOKB, APLEASE WAIT...Bappears on the screen whilechannel data is beingtransferred to the VHS deck.During this period(approximately 80 seconds), theVHS deck is not operable. It willexit the T-V LINK mode onceAPLEASE WAIT...B disappearsfrom the screen.ATTENTION:Preset positions on the front display panel increase from APR 1B;do NOT press any button on the unit or remote control until thefront display panel shows clock time, APR 1B or A– –:– –B asillustrated on page 19.● If you press any button on the unit or remote control whiledownloading is in progress, it will be interrupted.NOTES:● For details, refer to the instruction manual of your TV.● In the area where no TV station transmits a PDC (ProgrammeDelivery Control) signal, the unit can perform neither Auto ClockSet nor Auto Guide Programme Number Set.● If there is a power cut, or if you press A or SET UP whiledownloading or set up is in progress, it will be interrupted; besure to turn off the unit power once and try again from thebeginning.● Auto Clock Set may not function properly depending on thereception condition.● On this unit, the characters available for station names (ID) areA–Z, 0–9, –, Z, + and & (space). Some names of downloadedstations may differ from those of your TV. (A pg. 85)Preset DownloadATTENTION:You can use this function only with a TV offering T-V Link, etc.*Be sure to use a fully-wired 21-pin SCART cable.* Compatible with TVs offering T-V Link, EasyLink, Megalogic,SMARTLINK, Q-Link or DATA LOGIC via a fully-wired 21-pin SCARTcable. The degree of compatibility and available functions may differ bysystem.weENTERCABLE/SATDVDTV● Slide the TV/CABLE/SAT/DVD switch to DVD.● Perform steps 1 to 3 of AAuto Set UpB (A pg. 17) beforecontinuing.After APreset DownloadB is completed, perform AMonitor SetB onpage 21.ENTERSELECTSET UPEXITINITIAL SET UP > AUTO CH SETAUTO SET T-V LINKSELECT WITH @ THEN PRESS [ENTER]PRESS [SET UP] TO EXITENTERSELECTSET UPEXITINITIAL SET UP > T-V LINKT-V LINKPLEASE WAIT...CANCELSELECT WITH @ THEN PRESS [ENTER]PRESS [SET UP] TO EXIT