JVC 0505TNH-II-IM User Manual

Contents

14Before you can operate your remote control, youfirst need to install the batteries (included).Slide the cover on the back of the remote downtowards the bottom of the remote control. Inserttwo batteries (included) carefully noting the “+”and “–” markings, placing the “–” end in the unitfirst. Slide the cover back into place.When you change the batteries, try tocomplete the task within three minutes. If youtake longer than three minutes, the remotecontrol codes for your VCR, DVD, and/orcable box/satellite receiver may have to bereset. See pages 28 - 31.Step 2 – The Remote ControlKey Feature ButtonsThe four key feature buttons at the center of the remote can beused for basic operation of the television. The top and bottombuttons will scan forward and back through the availablechannels. To move rapidly through the channels usingJVC’s Hyperscan feature, press and hold CH+ or CH–. Thechannels will zip by at a rate of five channels per second. Theright and left buttons will turn the volume up or down. Thesebuttons are also marked with four arrows and are used withJVC’s onscreen menu system. To use the onscreen menus,press the MENU button.MUTINGMENU BACKGUIDEVCR CHANNEL VCR DVDCHCHVOL VOLOKBasic OperationTurn the television on and off by pressing the P OWER button at the top right cornerof the remote. If this is the first time you are turning on the TV, the interactiveplug-in menu appears.• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only ifyou need to operate a cable box.• Slide the VCR/DVD selector switch to VCR to control a VCR. Slide toDVD to control a DVD player. Please see pages 28 to 31 for instructions onprogramming your remote control to operate a cable box, VCR or DVD player.TPOWERTV CATVMULAVCR DVDLTI SCREENQuick Setup Getting Started