Menu
JD FC-P30A-UL Operator's Manual
        | |
OPERATOR’S MANUAL FC-P30A-UL4.OPERATION STORAGE1. Disconnect supply air when not in use.2. Always place the valve in the “OFF” position when not inuse.3. Wrap and store the hose on the provided hose wrap brack-et.4. Wrap and store the ground wire on the provided wire wrapbracket.5. Locate the park the Gas Caddy on a flat level surface, awayfrom any potential ignition sources, away from any potentialhazards that may impact or damage the Gas Caddy.6. Lock wheel brakes.7. Be certain that the fuel gage vent dome, indicator cap, filltube and fill tube cap are all present and secure. Replaceany missing parts immediately.Fig. 3PRODUCT SPECIFICATIONSWeight (empty): 154 lbs (69.5 kgs.)Capacity: 30 gal (114 L)Length: 31.25” (76 cm)Width: 25.0” (88.9 cm)Height: 39.50” (100.5 cm)Approx. Flow: 7 gpm (26 L pm) @ 40 PSIPUMPING FROM GAS CADDY TO VEHICLE1. Position the Gas Caddy near the vehicle and lock the wheelbrakes.2. Attach the ground wire clamp to the vehicle to a knownground surface.3. Place the hose inside the fill pipe of the vehicle fuel tank.4. Align valve handle so that the point is position to the “OUT”to vehicle position. (See Fig. 3)5. Connect shop air supply. WARNING: AIR SUPPLY MUSTNOT EXCEED 120 PSI.6. Squeeze the air throttle valve to operate pump. Closelymonitor flow to prevent overfilling or spilling.7. Release valve when desired amount is pumped.8. Turn the valve to the “IN” to tank position.9. Uncoil and raise the hose and briefly run the pump to returnany remaining fuel in the system to the tank.10.Coil and hang the hose on the hanger bracket.11.Turn valve handle to the “OFF” position. |
Related manuals for JD FC-P30A-UL
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved