Menu
JD FC-P30A-UL Operator's Manual
        | |
OPERATOR’S MANUAL FC-P30A-UL3.GENERAL PRODUCT DESCRIPTIONThe Gas Caddy is designed and approved to safely transferfuel to and from a vehicle. It may be used to safely store fuelduring vehicle service. It is approved for use with unleadedgasoline, diesel, and kerosene fuels.The FC-P30A comes standard with a 10 micron filter for usewith gasoline. Other filters are available for other fuels. Selectthe correct filter for the intended application. Proper filterselection is critical to achieving maximum pumping efficiencyand to properly remove contaminates from the fuel.Refer to the table shown in REPLACEMENT PARTS ANDACCESSORIES if you intend to pump different fuels.Fuel Type Filter TypeUnleaded Gasoline 10 micronDiesel and Kerosene 30 micronASSEMBLYOPERATIONPUMPING FROM VEHICLE TO GAS CADDY1. Wrap 2 inch NPT thread on fill tube 4-6 wraps with PTFEtape wrapping clockwise.2. Install quick-connect air fitting into air throttle valve.3. Assemble the discharge hose threading the 3/4 NPT fittinginto 90° fitting located on the front of the valve assembly.Tighten with wrench.4. Coil and hang the discharge hose on the hose hangerbracket on the side of the tank.5. Thread the 2 inch fill pipe and cap assembly onto the fittingin the center of the tank. Tighten by hand until secure.6. Remove tape from top of fuel gauge and install plasticindicator cap and plastic nut onto float assembly. Alignindicator mark to point diagonally across tank so that float isfree to move full range. Tighten nut by hand to secure capand fuel gage.NOTE: The regulator is factory preset to 40 psi (2.75 BAR).Adjust if desired to increase or decrease flow rate. Do not setregulator above 50 psi (3.45 BAR). This will not increase flowand result in premature wear of air motor and/or pump.1. Position the Gas Caddy near the vehicle and lock the wheelbrakes.2. Attach the ground wire clamp to the vehicle to a knownground surface.3. Place the hose inside the fill pipe of the vehicle fuel tank.4. Align valve handle so that the point is to the “IN” to tankpostilion. See Figure 2.5. Connect shop air supply. WARNING: AIR SUPPLY MUSTNOT EXCEED 120 PSI.6. Squeeze the air throttle valve to operate pump. Closelymonitor flow to prevent overfilling.7. Release valve when desired amount is pumped.8. Uncoil and raise the hose and breifly run the pump to returnany remaining fuel in the system to the tank.9. Coil and hang the hose on the hanger bracket.10. Turn valve handle to the “OFF” position.Tools and Supplies (not included):• TPFE tape• 1-1/16 inch open end wrench• 1/4” NTP Quick-connect fitting to connect to shop air. Fig. 1Fig. 2 |
Related manuals for JD FC-P30A-UL
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved