JBL PRX500 User Manual

Also see for PRX500 Series: User guide

Contents

JBL PRX500 User Manual Manual pdf 10 page image

10Changing VoltageYour PRX500 series speaker will typically be set at the factory to accommodate the power mains voltage in yourarea. Before you set up your PRX500 series speaker for the first time it is a good idea to verify that the settingof the selector is appropriate for the power in your area. In the event that you do need to change the voltage:• Make sure that the speaker is powered off and the AC is disconnected from the speaker.• Directly above the male IEC connector on the speaker is a voltage selector. Just slide theswitch to the appropriate setting.• Set the voltage selector switch to the 115V for (100-120V~) or 230V for (220-240V~) range settingas required for your area.• After having reconfirmed that the correct voltage is selected, reconnect the AC (IEC connector)and power the unit up.DO NOT UNDER ANY CIRCUMSTANCES OPERATE THE UNIT WITH THE WRONG VOLTAGE SELECTED.DOING SO MAY RESULT IN SERIOUS DAMAGE TO YOUR SPEAKER SYSTEM WHICH WILL NOT BECOVERED BY WARRANTY.Output WiringClass 2 output wiring.CLASS 2 WIRINGAC Power RequirementsStandard PRX500 series speaker systems are equipped with a multi-channel Crown Class-D power amplifierand loudspeaker specific DSP electronics and require appropriate AC power. Before plugging a PRX500speaker into an outlet ensure that it is able to provide the appropriate AC power as set on the speaker.A robust AC supply is necessary for maximum performance. If the supply is too weak the bass performance maybe affected and if it sags (drops) too much the system may self-mute to protect itself. As soon as the appropriateAC supply is restored it will continue to operate. Plugging multiple systems into the same outlet and longextension cord runs may affect the AC supply to the systems.CAUTIONIn compliance with safety agency criteria and proper system operation, it is critical that the system installerobserve all electrical safety practices at all times and provide proper earth grounding for all AC Powerconnections.Powering UpThe main power switch is located on the input panel on the back of the enclosure. Always ensure that thespeaker system is the last thing you power up, and the first thing to turn off when operating your complete PAsystem. If speaker systems are daisy chained together always turn off the last system in the chain first. Power“on” is indicated by the illumination of the logo on the front of the enclosure.The PRX500 Series Power Amplifier