Husqvarna W 40P Workshop Manual

Also see for W 40P: Operator's manual

Contents

English - 175.7 Engine oil5.7.1 To change the oilDrain the used oil while the engine is warm. Warm oildrains quickly and completely.1. Place a suitable container (A) below the engine tocatch the used oil, and then remove the oil filler capdipstick (B), O-ring (C) drain plug (D) and sealingwasher (E). See Figure 1.ACBE DFigure 12. Tilt the product to make sure the oil goes out of thedrain plug hole.3. Allow the used oil to drain completely into an ap-proved container, then reinstall the drain plug with anew sealing washer, and tighten it securely.Note: Improper disposal of engine oil can be harmfulto the environment. Dispose of used motor oil prop-erly. Put it in a sealed container, and take it a recy-cling center Do not throw it in the trash, pour it on theground, or pour it down a drain.5.7.2 Engine oil recommendationUse 4-stroke automotive detergent oil.-20 0 20 32 40403020100-10-20-30FC60 80 10050SAE 3010W-30Figure 2SAE 10W-30 is recommended for general use. Otherviscosities shown in the chart may be used when theaverage temperature in your area is within the recom-mended range.Repair instructions5.7.3 To fill the product with engine oil1. With the engine in a level position, fill to the edge ofthe oil filler hole with the recommended oil.Engine oil capacities:W40P: 0.45 L2. Screw in the oil filler cap dipstick securely