Husqvarna TE 250 Workshop Manual

Also see for 450 Rancher: Operator's manual Operator's manual Operator's manual Spare parts Operator's manual

R.11Part. N. 8000 B0148 (02-2008)SMR 450-RAssembling instructions for hand-guards kitThe kit consists of:1- Screw M8x55 (2)2- Collared bush (2)3- Notched bush (2)4- Spacer (2)5- Threaded spacer (2)6- Screw M6x40 (2)7- Bush (2)8- Washer (2)9- Self-locking nut M6 (2)10- Front tie rod (2)11- Screw M6x30 (4)12- Upper handlebar clamp (2)13- Lower handlebar clamp (2)14- Self-locking nut M6 (4)15- Left hand guard (1)16- Right hand guard (1)Insert in the handlebar, final zone (A), these parts: threaded spacer (5), spacer(4), notched bush (3), hand guard (15), collared bush (2) and screw (1) WITH-OUT tighten it completely.Assemble: the two clamps (12) and (13) on the handlebar (pay attention to theupper clamp: it is identified with a mark "UP" and an "ARROW" that shows thedirection of march of the motorcycle) then the rear screw WITHOUT tighten itcompletely.Assemble: the front tie rod (10) on the guard (15) using the screw (6), the tie rodon the handlebar clamps, front side, WITHOUT locking the screw (11) com-pletely.Now adjust all the hand guard assembly, then tighten completely FIRST theclamps front screw, THEN the clamps rear screw and the side screw (1).NOTE: the drawing shows the L.H. guard assembly, the R.H. guard assembly issymmetrical.