Husqvarna SR600 Operator's Manual

Contents

English – 7ASSEMBLYKBADGCFI HEE1. Slide the plastic sleeve (wear protection) (A) onto thetube (B).2. Fit the gearbox (C) on the tube (B). Tighten clamp screw(D) at the gearbox. Tighten the two locking screws (E)on the gearbox.3. Press one of the roller shafts (F) onto one of the twooutput drive shafts from the gearbox. If necessary rotatethe roller shaft so that the hole for the pin lines up withthe corresponding hole in the drive shaft.4. Secure the roller shaft on the drive shaft using a pin (G)and hairpin spring (H).5. Slide one of the sweeper rollers (I) onto the fitted shaft.The end with the extended rubber blades must be fittedclosest to the gearbox. Slide the sweeper roller on until ittouches the pin.6. Secure the roller to the shaft using a split pin (K) (seediagram). The split pin must be flush with the outer endof the roller, so you may need to push on the end plateslightly to fit it. Bend back the legs of the split pin asshown, to ensure that the sweeper roller is held in place.7. Repeat steps 1–7 to fit the shaft and roller on the otherside.CAUTION! The rollers are identical, but they must bothbe fitted with the extended rubber blades nearest thegearbox.