Husqvarna QHIO660P User Manual

Problem Possible cause RemedyThe fuse is blown. Make sure that the fuse is thecause of the malfunction. If thefuse is blown again and again,contact a qualified electrician.You do not set the heat set‐ting for 50 seconds.Activate the hob again and setthe heat setting in less than 50seconds.You touched 2 or more sen‐sor fields at the same time.Touch only one sensor field.Pause operates. Refer to "Daily use".There is water or fat stainson the control panel.Clean the control panel.You cannot select themaximum heat setting forone of the cooking zones.The other zones consumethe maximum available pow‐er.Your hob works properly.Reduce the heat setting of theother cooking zones connec‐ted to the same phase.Refer to "Power manage‐ment".An acoustic signal soundsand the hob deactivates.An acoustic signal soundswhen the hob is deactiva‐ted.You put something on one ormore sensor fields.Remove the object from thesensor fields.The hob deactivates. You put something on thesensor field .Remove the object from thesensor field.Residual heat indicatordoes not come on.The zone is not hot becauseit operated only for a shorttime or the sensor is dam‐aged.If the zone operated sufficient‐ly long to be hot, speak to anAuthorised Service Centre.Hob²Hood does not work. You covered the control pan‐el.Remove the object from thecontrol panel.You use a very tall pot whichblocks the signal.Use a smaller pot, change thecooking zone or operate thehood manually.The sensor fields becomehot.The cookware is too large oryou put it too near to thecontrols.Put large cookware on the rearzones, if possible.There is no sound whenyou touch the panel sen‐sor fields.The sounds are deactivated. Activate the sounds.Refer to "Daily use".www.husqvarna-electrolux.se36