Husqvarna PG 400 Operator's Manual

Also see for PG 400: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

1. Connect the dust extractor to the product. Use a 50mm/2 in hose.2. Make sure that the filters in the dust extractor areclean and not damaged. Monitor the dust during theoperation.MaintenanceIntroductionWARNING: Before you domaintenance, you must read andunderstand the safety chapter.For all servicing and repair work on the product, specialtraining is necessary. We guarantee the availability ofprofessional repairs and servicing. If your dealer is nota service agent, speak to them for information about thenearest service agent.For more detailed information, refer towww.husqvarnacp.com.Daily maintenanceDaily maintenance means that you clean the product.Also that you do a check of the electrical supply, thebrush strip and the grind holder.To clean the productCAUTION: A blocked air intakedecreases the performance of the productand can cause the motor to become too hot.• Always pull out the plug from the mains outlet beforeyou clean, do maintenance or assemble the product.• Always clean all the equipment at the end of thework day. Do not use a high pressure washer toclean the product.• Always do the maintenance on level ground.• Remove blockage from all air openings. The productmust always have sufficiently cool temperature.To do a check of the electrical supplyWARNING: Do not use damagedcables. A damaged cable can cause seriousinjury or death.• Make sure that the power cord and extension cableare not damaged and in good condition.• Do not use the product if the power cord isdamaged. Let an approved service center repair theproduct.To do a check of the brush strip• Make sure that the brush strip is full.• Make sure that the brush strip touches the surface.To do a check of the grind holderCAUTION: The condition of the grindholder is important for the performance andthe safety.16 2258 - 002 - 25.10.2023