Husqvarna K 7000 Ring Operator's Manual

Also see for K 7000 Ring: Operator's manual Operator's manual

3. Adjust the water flow with your thumb during theoperation.To start the product1. Hold the rear handle with your right hand.2. Push the power trigger lockout and hold in the powertrigger.3. Let the product operate with no load for minimum 30seconds.Cutting depthThis product can cut a maximum depth of 325 mm/12.8in (A).The time to complete a cut is longer if you cut at the fulldepth directly. It is faster to complete the cut if you cut4-5 times until the depth is 325 mm/12.8 in.54321ATo make a straight cut1. Attach a long straight object as a support along theline where the cut is to be made.2. For the best result, cut first with a power cutter with aspecial pre-cut blade.WARNING: Do not use a powercutter with a standard cutting blade forthis first cut. A standard cutting blademakes a slot cut that is too thin. Whenyou then cut with the ring cutting blade,the too thin slot causes dangerouskickback and pinching of the ring cuttingblade.3. Cut the full length of the cut to a depth of 2-3cm/0.79-1.18 in. Keep the cutting blade against thesupport to make the cut straight.4. Lift the cutting blade from the cut.5. Go back to the start of the cut and cut 2-3 cm/0.79-1.18 in. again, until the full length of the cut hasa depth of 5-10 cm/1.97-3.94 in.6. Continue to cut to necessary depth.To cut holesWARNING: Make sure that large cutpieces cannot fall on the operator or theproduct when you cut.CAUTION: Cut pieces can fall andcause damage to the product if the cutsare made in the incorrect sequence. Alwaysmake the lower horizontal cut before the tophorizontal cut.1. Attach a support (A) across the area to be cut (B) tomake sure that the cut piece cannot fall.AB1461 - 003 - 17.04.2024 19