Husqvarna EPOS RS1 Operator's Manual

5. Install the cable cover.6. Connect the low-voltage cable from the referencestation to the power supply.7. Attach the low-voltage cable to the wall or pole withcable ties.CAUTION: If the low-voltagecable is not attached tightly with cableties, it can become damaged in hardwind.8. Put the power supply 30-200 cm / 1-6.5 ft. abovethe ground. Refer toTo examine where to put thepower supply on page 7.9. Connect the power supply cable to a 100-240Vpower outlet.Note: The LED indicator of the reference stationflashes green for some minutes. The LED indicator issolid green when the reference station is in operation.Refer toLED indicator lamp on the reference station onpage 23.3.10.6 Installation of the map objectsRead and understand the instructions about where toinstall the map objects. Refer toTo examine where toinstall the virtual boundaries on page 9.On the map you can install the objects that follow in theapp:•Work areas (A)•Stay-out zones (B)•Transport path (C)•Charging station (D)•Maintenance point (E)•Reference station (F)•Work area (Secondary area) (G)AGBADEC FFor a complete map installation, you must install a workarea and a charging station on the map.A work area is specified by virtual boundaries. Maximumwork areas and secondary areas can be installed on amap.There are two types of work areas:• A work area that has a charging station in it orconnected to it with a transport path where theproduct operates automatically.• A secondary area is a work area with no chargingstation and no transport path. The product must bemoved manually to and from the work area.A transport path is a specified path between the dockingpoint in front of the charging station and a work area.The product can operate automatically in this path, butdoes not cut grass. A transport path can temporarily beenabled and disabled in the app.Stay-out zones can be made if there are areas wherethe product must not operate. A stay-out zone isspecified by virtual boundaries. Stay-out zones cantemporarily be enabled and disabled in the app.A maintenance point is a specified position where theproduct can be parked at. This can for example be usedfor a service point where maintenance of the productis done. The maintenance point is connected to thedocking point with a path.2211 - 002 - 30.11.2023 Installation - 15

/ 304

Related manuals for Husqvarna EPOS RS1

Husqvarna Automower Connec Operator's Manual

This manual is suitable for:

EPOS RS1

Husqvarna EPOS RS1 Operator's Manual

Product

Learn More

Legal