Menu
Husqvarna DXR 145 Operator's Manual
Also see for DXR 145: Operator's manual
                                                                                                                        |
Bx4AAC30x1. Move the product until you have access to all greasenipples. The grease nipples are shown in theillustration.2. Stop the product and disconnect the power cord.Refer toTo stop the product (DXR 145) on page 62.3. Clean the grease nipples.4. Replace broken or blocked grease nipples.5. Lubricate the grease nipples with a grease gun.Push the grease gun 2–3 times or until grease canbe seen at the edges. Refer toLubricants on page110.6. Lubricate all joints and cylinder mountings in theoutriggers.7. Lubricate all joints and cylinder mountings in the armsystem.8. Lubricate the 2 grease nipples (A) on the gear ringbearing and the gears of the gear ring (B).a) Extend the arm system until the arm systempoints straight forward.b) Open the inspection door (C) on the tower to getaccess to the 2 grease nipples.c) Lubricate the grease nipples with a grease gun.Push the grease gun 2–3 times.d) Start the product. Make sure that you are at asafe distance. Refer toTo start the product (DXR145) on page 52.e) Turn the tower 180˚.f) Stop the product and disconnect the power cord.Refer toTo stop the product (DXR 145) on page62.g) Lubricate the grease nipples again with a greasegun. Push the grease gun 2–3 times.To lubricate the product (DXR 275,DXR 305, DXR 315)CAUTION: If the procedure forlubrication is not followed, there is a highrisk that the seals of the gear ring arepushed out. If the seals are pushed out, dirtcan go into the ball bearing of the gear ringand cause damage. Damaged seals mustbe replaced.1401 - 002 - 15.10.2021 81 |
Related manuals for Husqvarna DXR 145
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved