Menu
Husqvarna DS250 Series Operator's Manual
Also see for DS 150: Operator's manualOperator's manualOperator's manualOperator's manualOperator's manual
                                        | |
4. Attach the product with the nut.To attach the product with a Husqvarnavacuum plateWARNING: Do not use the product incombination with the vacuum plate whenyou drill in walls or ceilings.WARNING: The support surface must be flatand of good quality. The product canbecome loose if the vacuum plate cannotseal fully against the surface.WARNING: Use of vacuum plate is onlyrecommended together with theseHusqvarna drill motors: DM200, DM220,DM230, DM280 High speed. Use of otherdrill motors can cause the product tobecome loose.1. Loosen the level adjustment screws. They must beabove the bottom of the vacuum plate.2. Connect the vacuum hose and start the pump.WARNING: The minimum pressure mustbe -0.85 bar to seal the vacuum platetightly to the surface.3. Tighten the level screws until you feel pressure onthe screw.WARNING: The level adjustment screwsmust touch the surface when when youuse the vacuum plate. If not, the vacuumplate can come loose.To install the product with an all thread rod• Use an all thread rod to install the product to a wallor ceiling.• Use an all thread rod when it is not possible to usean expander bolt.• Use washers and nuts to tighten the all thread rod.OperationTo do before you operate the product• Read the operator's manual carefully and make surethat you understand the instructions.• Read the operator's manual for the drill motorcarefully and make sure that you understand theinstructions.• Do the daily maintenance. Refer toDailymaintenance on page 10.To adjust the angle of the drill columnThe drill column can be tilted 0–60°.1341 - 002 - 24.10.2019 9 |
Related manuals for Husqvarna DS 150
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved