Husqvarna Automower 310 Operator's Manual

Also see for 315, 320: Operator's manual Operator's manual Quick guide Operator's manual Operator's manual

To enable the GeoFence functionGeoFence is a GPS-based theft protection thatmakes a virtual fence for the product. You will geta message if the product is moved on the otherside of the GeoFence.1. Put the product in the center of the workarea.2. Do steps 1–3 inTo get access to the menuon page 23.3. Use the arrow buttons and the OK button tomove through the menu structureAccessories > Automower Connect >GeoFence > Activate GeoFence.4. Push the OK button.5. SelectActivate GeoFence and push the OKbutton.To set a new center point for the Geofencefunction1. Put the product in the center of the workarea.2. Do steps 1–3 inTo get access to the menuon page 23.3. Use the arrow buttons and the OK button tomove through the menu structureAccessories > Automower Connect >GeoFence > New center point.4. Push the OK button.To set the GeoFence level of sensitivityThe higher level of GeoFence sensitivity, theeasier the alarm starts.1. Do steps 1–3 inTo get access to the menuon page 23.2. Use the arrow buttons and the OK button tomove through the menu structureAccessories > Automower Connect >GeoFence .3. Use the arrow buttons to select level ofGeoFence sensitivity.4. Push the BACK button.To use the SMS functionThe SMS function sends you an SMS when theproduct is moved out of the GeoFence.1. Do steps 1–3 inTo get access to the menuon page 23.2. Use the arrow buttons and the OK button tomove through the menu structureAccessories > Automower Connect >Communication > Use SMS.3. Push the OK button.4. Use the arrow buttons and the OK button tomove through the menu structureAccessories > Automower Connect >Communication > SMS phone numbers.5. Push the number buttons to enter thetelephone number with country code. Forexample (+)46701234567.6. Push the BACK button.Note: There is a maximum of 10 SMS eachmonth from the product.NetworkAPN settingsThe product must specify APN settings to be ableto use and send data via the mobile net. Settingsfor Husqvarna SIM is default.3.9.11.5 HeadlightsTo set the schedule for the headlights1. Do steps 1–3 inTo get access to the menuon page 23.2. Use the arrow buttons and the OK button tomove through the menu structureAccessories > Headlights > Schedule.3. Select betweenAlways ON, Evening only,Evening & night orAlways OFF.Note:Evening only will start the schedule for theheadlights at sunset and stop at midnight.Evening & night will start the schedule for theheadlights at sunset and stop at sunrise.To set the Flashes when fault functionThe headlights flashes if the product stops tooperate because of a fault ifFlashes when fault isenabled.1. Do steps 1–3 inTo get access to the menuon page 23.2. Use the arrow buttons and the OK button tomove through the menu structureAccessories > Headlights > Flashes whenfault.3. Use the OK button to enable or disable theFlashes when fault function.32 - Installation 1220 - 001 -