Husqvarna AUTOMOWER 315 Operator's Manual

Also see for 315, 320: Operator's manual Operator's manual Quick guide Operator's manual Quick guide

Contents

English - 56MENU FUNCTIONSAdvancedUnder the Advanced heading, there are even moresettings relating to the behaviour of the roboticlawnmower. The settings in this menu are only requiredif additional control of the lawnmower is definitely needede.g. in very complex gardens. The factory settings areselected in a way that should suit most working areas.Corridor widthThe corridor width is a measure of how far from the guidewire/boundary wire the robotic lawnmower is allowed totravel when it follows this to and from the charging station.The area beside the wire which the robotic lawnmowerthen uses is called the Corridor.The aim of operating at varying distances from the wireis reduce the risk of tracks forming. To reduce the riskof tracks forming, it is recommended to select the widestcorridor possible allowed by the size of the working area.The robotic lawnmower itself adjusts the corridor widthaccording to the size of the working area when followingalong a guide wire. The inbuilt automatic mechanismallows the robotic lawnmower to vary the distance fromthe wire depending on where in the working area it islocated. It automatically makes the corridor narrower innarrow passages for instance.The factory settings can be used for many workingareas, i.e. the robotic lawnmower itself can use the inbuiltfunctions to operate in the widest possible corridor.In more complex gardens e.g. where the guide wire isplaced close to obstacles which cannot be isolated usingthe boundary loop, operational safety can be improved bycarrying out some of the manual settings outlined below.Corridor width > BoundaryCorridor width is specified in intervals from 1-9. The firstnumber in the interval specifies the shortest distance tothe boundary loop and the second number the longestdistance.The distance the robotic lawnmower maintains fromthe boundary loop varies depending on the layout ofthe working area. Use the Test function in Installation> Lawn Coverage > Area X > More > Test to test thedifferent values.Use the number keys to specify the required interval.The factory setting is 3-6.3023-0203023-0213012-14233012-1416OM_1157863-26_HQ 310,315,EN_160229.indd 56 2016-02-29 10:52:26