Husqvarna AUTOMOWER 315 Operator's Manual

Also see for 315, 320: Operator's manual Operator's manual Quick guide Operator's manual Quick guide

Contents

3023-0053012-6863012-1319AB3023-006English - 24INSTALLATIONBoundaries within the working areaUse the boundary wire to isolate areas inside the workingarea by creating islands around obstacles which cannotwithstand a collision, for example flowerbeds, bushes andfountains. Lay the wire up to and around the area to beisolated, and then return it back along the same route.If pegs are used, the wire should be laid under the samepegs on the return route. When the boundary wires toand from the island are laid close together, the roboticlawnmower can drive over the wire.Obstacles that can withstand a collision, for example,trees or bushes taller than 15 cm, do not need to beisolated with the boundary wire. The robotic lawnmowerwill turn around when it collides with this type of obstacle.It is recommended to isolate all fixed objects in andaround the working area. This results in the mostgentle and silent operation and prevent the roboticlawnmower from getting stuck in the objects underany circumstances.Obstacles that slope slightly, for example stones or largetrees with raised roots, must be isolated or removed.Otherwise the robotic lawnmower can slide up onto thiskind of obstacle causing the blades to be damaged.Secondary areasIf the working area consists of two areas which therobotic lawnmower has difficulty travelling between, it isrecommended to set up a secondary area. Instances ofthis are 40% slopes or a passage that is narrower than60 cm. Lay the boundary wire then around the secondaryarea so that it forms an island outside of the main area.The robotic lawnmower must be moved manuallybetween the main and secondary area when the lawnin the secondary area has to be cut. The Secondaryarea (A) operating mode must be used as the roboticlawnmower cannot travel on its own from the secondaryarea to the charging station. See 5.1 Operation selectionStart on page 40. In this mode, the robotic lawnmowerwill never look for the charging station but will mow untilthe battery runs out. When the battery is flat, the roboticlawnmower will stop and the Needs manual chargingmessage will appear in the display. Then place the roboticlawnmower in the charging station to charge the battery.If the main area has to be cut straight after charging, theSTART button must be pressed and the Main area (B)selected before closing the hatch.IMPORTANT INFORMATIONThe boundary wire may not be crossed onits way to and from an island.OM_1157863-26_HQ 310,315,EN_160229.indd 24 2016-02-29 10:51:46