Husqvarna AUTOMOWER 310 Operator's Manual

Also see for 315, 320: Operator's manual Operator's manual Quick guide Operator's manual Operator's manual

always select the maximum cutting height thefirst weeks after installation and then lower theheight one step at a time every second week untilthe desired cutting height has been reached.A defective splicing of the loop wire can also leadto disruptions several weeks after the splice wasdone. A faulty splice can, for example, be theresult of the original coupler not being pressedtogether hard enough with a pair of pliers, or thata coupler of lower quality than the originalcoupler has been used. Please first check allknown splices before further troubleshooting isdone.A wire break can be located by gradually halvingthe distance of the loop where the break mayhave occurred until there is only a very shortsection of the wire left.The following method does not work ifECOmode is activated. Make sure first thatECOmode is switched off. Refer toECO mode onpage 31.1. Check that the indicator lamp in the chargingstation flashes blue, which indicates a breakin the boundary loop. Refer toIndicator lampin the charging station on page 49.2. Check that the boundary wire connections tothe charging station are properly connectedand not damaged. Check that the indicatorlamp in the charging station is still flashingblue.ARALGUIDEPOWER3. Switch the connections between the guidewire and the boundary wire in the chargingstation.Start by switching connection and .If the indicator lamp has a solid green light,then the break is somewhere on theboundary wire between and the point wherethe guide wire is connected to the boundarywire (thick black line in the illustration).GuideGUIDEALTo rectify the fault you will need boundarywire, connector(s) and coupler(s):a) If the suspected boundary wire is shortthen it is easiest to exchange all of theboundary wire between and the point wherethe guide wire is connected to the boundarywire (thick black line).b) If the suspected boundary wire is long(thick black line) then do as follows: Put andback to their original positions. Thendisconnect . Connect a new loop wire to .Connect the other end of this new loop wireat the middle of the suspected wire section.52 - Troubleshooting 1440 - 003 - 09.03.2020