Husqvarna AUTOMOWER 310 Operator's Manual

Also see for 315, 320: Operator's manual Operator's manual Quick guide Operator's manual Operator's manual

2. Do steps 1–3 inTo get access to the menuon page 24.3. Use the arrow buttons and the OK button tomove through the menu structureSecurity >Advanced > New loop signal.4. Await confirmation that the loop signal hasbeen generated. This normally takes about10 seconds.To change the PIN-code1. Do steps 1–3 inTo get access to the menuon page 24.2. Use the arrow buttons and the OK button tomove through the menu structureSettings >Security > Advanced > Change PIN-code.3. Enter the new PIN code.4. Push the OK button.5. Enter the new PIN code.6. Push the OK button.7. Make a note of the new PIN code. Refer toIntroduction on page 3.To change the length of the alarm1. Do steps 1–3 inTo get access to the menuon page 24.2. Use the arrow buttons and the OK button tomove through the menu structureSecurity >Advanced > Duration > Duration of alarm.3. Use the arrow buttons to select a timeinterval of 1 to 20 minutes.4. Push the BACK button.To change the length of the time lock1. Do steps 1–3 inTo get access to the menuon page 24.2. Use the arrow buttons and the OK button tomove through the menu structureSecurity >Advanced > Duration > Duration of timelock.3. Use the number buttons to select a timeinterval of 1–90 days.4. Push the BACK button.3.10.3.6 MessagesIn this menu the previous fault and informationmessages can be found. For some of themessages, there are tips and advice to help torectify the fault. Refer toTroubleshooting on page43.If the product is disrupted in any way, forexample it is trapped or the battery is low, amessage is saved relating to the disruption andthe time it happened.If the same message is repeated several times,this may indicate that an adjustment to theinstallation or the product is required. Refer toInstallation on page 15.To read the messages1. Do steps 1–3 inTo get access to the menuon page 24.2. Use the arrow buttons and the OK button tomove through the menu structureMessages> Fault messages andMessages > Infomessages.3. Read the messages and read theTroubleshooting to get information andrecommendations to correct the faults.3.10.4 Weather timerWeather timer automatically adjust the cuttingtime to the growth of the grass. The product isnot permitted to operate more than the schedulesettings.Note: When usingWeather timer, it isrecommended to make as much operating timeas possible available forWeather timer. Do notrestrict the schedule more than necessary.The first operation of the day is set by theschedule settings. The product always complete1 mowing cycle, and thenWeather timer selectsif the product will continue to operate or not.Note:Weather timer is reset if the product doesnot operate for more than 50 hours, or if aResetof all user settings is done.Weather timer is notchanged if aReset of schedule settings is done.3.10.4.1 To set the Weather timer1. Do steps 1–3 inTo get access to the menuon page 24.26 - Installation 1440 - 003 - 09.03.2020