Husqvarna 323C Operator's Manual

Also see for 325L X Series: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

10 – EnglishASSEMBLYFitting the loop handle(323C, 325Cx)• Position the handle on the shaft. Note that the handlemust be mounted below the arrow on the shaft.• Fit the screw, securing plate and wing nut as shown in thediagram.• Tighten the wing nut.Fitting the loop handle(323L, 323LD, 325Lx, 325LDx)• Clip the loop handle onto the shaft. Note that the loophandle must be fitted between the arrows on the shaft.• Slide the spacer into the slot in the loop handle.• 323L/323LD: Fit the nut, washer and screw.325Lx/325LDx: Fit the nut, knob and screw. Do notovertighten.• Now adjust the trimmer to give a comfortable workingposition. Tighten the bolt/knob.Assembling and dismantling thetwo-piece shaft(323LD, 325LDx)Assembly:• Make sure the knob is loose.• Align the cut-out in the lower part of the shaft with thecoupling locking tab on the upper part of the shaft. Thenlock the sections together.• Tighten the knob.Dismantling:• Undo the knob (at least three turns).• Push the knob towards the coupling.• Carefully twist the lower half of the shaft to unlock it.• Hold both parts of the shaft and pull the lower part of theshaft out of the coupling.Fitting the trimmer headWhen fitting the cutting attachment it is extremely importantthat the raised section on the drive disc/support flangeengages correctly in the centre hole of the cutting attachment.If the cutting attachment is fitted incorrectly it can result inserious and/or fatal personal injury.! WARNING! Never use a cutting attachmentwithout an approved guard. See the chapteron Technical data. If an incorrect or faultyguard is fitted this can cause seriouspersonal injury.