Husqvarna 250 PS Workshop Manual

Also see for 250PS: Operator's manual

Contents

3683467512Heat the magnet side of the crankcase.Grease and fit a new crankcase gasket. Place it on thedrive side of the crankcase, line up the gasket with thebolts and pull the two crankcase halves together usingthe fitting tool.Fit the drive side sealing ring using the sleeve on thefitting tool (no. 502 50 30-12). The sealing ring must beflush with the crankcase surface.The crankcase bolts are of different length and should befitted as follows:1-5 l=30 mm6-7 l=60 mmTighten all the bolts, starting with the ones closest to thecrankshaft.Always fit a new, greased O ring. Smear the 3 housingbolts with Loctite. Then tighten.For Husqvarna Parts Call 606-678-9623 or 606-561-4983www.mymowerparts.com