Husqvarna 2-20DT Operator's Manual

Also see for 2-20DT: Operator's manual

Problem Cause SolutionThe motor does notstart.A phase of the power supply is missing. Do a check of the power supply.A phase of the power supply is incorrect. Adjust the phase.The emergency stop button is engaged. Turn the emergency stop button clockwise todisengage.There is no power in the drive system. Start the drive system, then start the blastmotor.The motor protection switch is engaged. Start the product again. Do a check of thepower supply.The extension cable is disconnected or dam-aged.Connect the extension cable or if it is neces-sary, replace the extension cable.A component is damaged. Speak to an approved Husqvarna serviceagent.The product stops af-ter a while.The motor protection switch releases be-cause of overload.Speak to an approved Husqvarna serviceagent.The motor has a damage. Do a check of the motor.A safety fuse or a fault current breaker is on. Speak to an approved Husqvarna serviceagent.Cables are damaged. Do a check of the cable and replace if neces-sary.The drive systemdoes not operate cor-rectly.The drive system is not engaged. Install the quick release pin.Safety fuse or the drive system motor isdamaged.Speak to an approved Husqvarna serviceagent.The control panel is damaged. Speak to an approved Husqvarna serviceagent.The potentiometer is damaged. Speak to an approved Husqvarna serviceagent.Transportation, storage and disposalTransportationWARNING: Be careful duringtransportation. The product is heavy and cancause injury or damage if it falls or movesduring transportation.CAUTION: Do not tow the productbehind a vehicle.• Make sure that the power supply is disconnectedbefore transportation.• Make sure that the electrical cable and dust extractorhose are disconnected before transportation.• Remove the abrasive before transportation.• The wheels let you move the product shorterdistances. For longer distances, lift the product tomove it or put the product on a vehicle.• Put some type of protection on the productduring transportation. The protection keeps naturalelements such as rain and snow away from theproduct.• Engage the drive system during transportation. RefertoTo engage the drive system on page 11.To set the product in transport positionWARNING: Do not lift the product untilthe blastwheels have fully stopped.26 2037 - 002 - 06.04.2023