Husqvarna 2-20DT Operator's Manual

Also see for 2-20DT: Operator's manual

6. Push the ON button to start the control panel.7. Engage the drive system. Refer toTo engage thedrive system on page 11.8. Push the ON button to start the blastmotors.9. Wait until the ammeters are in idle position.10. Turn the speed control dial to set the drive speed.To operate the productWARNING: This product is forrearward operation only. Do not move theproduct forward during operation.WARNING: Do not lift the blasthousingduring operation. Abrasive comes out of theproduct at high speed and can cause injury.1. Make sure that the work area is safe. Refer toWorkarea safety on page 7.2. Fill the abrasive separator with abrasive. Fill theseparator with abrasive when necessary. Refer toTofill the product with abrasive on page 15.3. Start the product. Refer toTo start the product onpage 16.4. Engage the drive system. Refer toTo engage thedrive system on page 11.5. Operate the drive system lever.6. Pull the abrasive control lever to open the abrasivevalve. Refer toTo operate the abrasive valves onpage 13.2037 - 002 - 06.04.2023 17