Husqvarna 125LDx Operator's Manual

Also see for 125C: Operator's manual Operator's manual Workshop manual

Contents

9ASSEMBLYF itting the trimmer guard andtrimmer headS Fit the correct trimmer guard (D) for usewith the trimmer head. Hook the trimmerguard/combination guard onto the fittingon the shaft and secure with the bolt (E).Assembling and dismantlingthe two--piece shaftAssembly:S Loosen the coupling by turning the knob.S Align the tab of the attachment (A) withthe arrow on the coupling (B).S Push the attachment into the coupling untilthe attachment snaps into place.S Before using the unit, tighten the knob se-curely.S Fit the drive disc (F) on the output shaft.S Turn the shaft until one of the holes in thedrive disc aligns with the correspondinghole in the gear housing.S Insert hex wrench (G) in the hole to lockthe shaft.S Screw on the trimmer head (H) in the op-posite direction to the direction of rota-tion.NOTE: Make sure unit is assembled cor-rectly as shown in this manual.Fitting the loop handleS Position the handle on the upper shaftleaning towards the engine. Note that thehandle must be mounted between thetwo arrows on the shaft.S Fit the screw, securing plate and wingnut as shown in the diagram.S Tighten the wing nut.DEDFGHS To dismantle, follow the instructions inthe reverse order.BADismantling:S Loosen the coupling by turning the knob(at least three times).S Push and hold the button (C). Whilesecurely holding the engine end, pull theattachment straight out of the coupling.C