Husqvarna 125BV x-series Operator's Manual

Also see for 125B: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Contents

Fuel mixture

DESCRIPTIONGround wire• The ground wire (G) reduces staticbuild-up during operation in dry condi-tions.G/Inlet cover• An inlet cover (H) is located on the sideof the fan housing. Opening this coverallows access for cleaning and inspect-ing the impeller (125Bx_sERIES and125BVx_sERIES only). If the vacuum tubeis used, it must be fitted to the opening inthe inlet cover. To open the inlet cover,use a tool to lift the edge of the coveropposite the hinge (indicated by arrowon inlet cover).H d' "- _WARNING: Never start the blower Iif the inlet cover is not closed, isdamaged or cannot be closed(except if the vacuum tube is fitted).Cutters(125Bx_sERIES and 125BVx_sERIES )• Two cutters (J) are fastened to the impel-ler. The cutters are there to mulch leavesand other debris that have been vacuumedbefore they enter the collection bag.Blower tube and nozzleNOTE: The tube clamp bolt and nut mustbe installed prior to initial use (see the gen-eral description of the blower on page 6).• The blower tube (K) has a pegged slotmounting system to the unit. To install orremove the blower tube (or collection bagtube for the 125BVx_sERES), the tubeclamp bolt must be removed. Align slot inthe blower air outlet with the raised rib onthe tube and insert tube until the holes inthe tube and housing align. Re-insert thetube clamp bolt and tighten.The nozzles (L) have a bayonet mountfor connection to the blower tube. Air ischanneled through the blower tube to thenozzles, where the air discharge velocityincreases and the air stream dischargepattern is formed to provide best perfor-mance. The length of the blower tubecan be adjusted by twisting the nozzle tothe left to disengage the bayonet mountand sliding the nozzle to the appropriateposition. Twist the nozzle to the right untila click is felt to resecure the nozzle.Starter device and starter handle• The starter device (M) is located on theside of the engine shrouding and en-gages the crankshaft only when thestarter handle (N) is pulled.N .... __M jFuel cap• The fuel cap (O) is located at the rear ofthe engine shrouding on the fuel tankand has a seal to prevent fuel from leak-ing out.,,, _Air filter• The air filter (P) consists of a fiber filtermedium in a resilient frame. The air filtershould be cleaned at specific intervals(see Maintenance section). Otherwise,the blower will consume too much fuel,the performance will be reduced and anoily deposit may form on the spark plugelectrodes.545186705 Rev. 3 7/1/08 English-9