Husqvarna 120iTK4-H Operator's Manual

Also see for 120iTK4-H: Operator's manual Operator's manual Operator's manual

4. Make sure that the handle and safety devices arenot damaged and are attached correctly. Do notoperate a product with missing parts or is changedfrom its initial specification. Use protective gloveswhen it is necessary.5. Make sure that the covers are not damaged and areattached correctly, before you operate the product.To connect the battery charger1. Connect the battery charger to the voltage andfrequency that is specified on the rating plate.2. Put the plug in a grounded socket outlet. The LEDon the battery charger flashes green one time.Note: The battery does not charge if the batterytemperature is more than 50 °C/122 °F. If thetemperature is more than 50 °C/122 °F, the batterycharger makes the battery become cool before thebattery charges.To connect the battery to the batterychargerNote: Charge the battery if it is the first time that youuse it. A new battery is only 30% charged.1. Make sure that the battery is dry.2. Connect the battery to the battery charger.3. Make sure that the green charging light on thebattery charger comes on. That means that thebattery is connected correctly to the battery charger.4. When all LEDs (A) on the battery come on, thebattery is fully charged.BLiA5. To disconnect the battery charger from the mainssocket, pull the plug. Do not pull the cord.6. Remove the battery from the battery charger.Note: Refer to the battery and battery chargermanuals for more information.To connect the battery to the productWARNING: Only use Husqvarnaoriginal batteries in the product.1. Make sure that the battery is fully charged.2. Put the battery into the battery holder of the product.The battery must move into the holder easily, if not, itis not installed correctly.3. Push the lower part of the battery and push it in fullyinto the battery holder. The battery locks into positionwhen you hear a click.4. Make sure that the latches lock in position correctly.To start the product1. Push and hold the start/stop button until the greenLED comes on.2. Pull the power trigger lockout rearward and hold thepower trigger.To operate the product• Start near the ground and move the product upalong the hedge when you cut the sides.12 1637 - 003 - 06.04.2021