Husqvarna 115iPT4 Operator's Manual

Also see for 115iPT4: Operator's manual

Contents

1. Push the SavE button. The LED comes on to showthat the function is on.2. Push the SavE button again to stop the SavEfunction.To stop the product1. Release the power trigger.2. Push and hold the stop button until the green LEDlight goes off.3. Remove the battery from the product. Push the 2release buttons and pull out the battery.MaintenanceIntroductionWARNING: Read and understand the safetychapter before you do maintenance work onthe product.WARNING: Remove the battery before youdo maintenance on the product.Maintenance scheduleWARNING: Remove the battery before youdo maintenance.The following is a list of the maintenance steps that youmust do on the product. Refer to the tasks in themaintenance chapter for more information.Maintenance Daily Weekly MonthlyClean the external parts of the product with adry cloth. Do not use water. XMake sure that the start and stop buttonworks correctly and are not damaged. XMake sure that the power trigger and thepower trigger lockout function correctly froma safety point of view.XMake sure that all controls work and are notdamaged. XKeep the handles dry and clean. Makes surethat that there is no oil and grease on thehandles.XMake sure that the saw chain cover is notdamaged. Replace the saw chain cover if it isdamaged.XMake sure that the screws and nuts are tight. XClean the oil tank cap XMake sure that the battery release buttonson the battery works and locks the battery inthe product.X707 - 001 - 27.06.2018 13