Husqvarna 115H Operator's Manual

Also see for 115H: Workshop manual

5. Check that the indicator lamp on theON/OFF button is not lit.4.6 To charge the batteryWhen the product is new or has been stored for along period, the battery can be empty and needsto be charged before starting. In theMain areamode, the product automatically alternatesbetween mowing and charging.WARNING: Only charge the productusing a charging station which isintended for it. Incorrect use may resultin electric shock, overheating orleakage of corrosive liquid from thebattery.In the event of leakage of electrolyteflush with water and seek medical helpif it comes in contact with the eyes etc.1. Press the ON/OFF button to start theproduct.2. Place the product in the charging station.Slide the product in as far as possible toensure proper contact between the productand the charging station. Refer to contactand charging strips inProduct overview onpage 43. The display shows a message that chargingis in progress.4.7 Adjust the cutting heightThe cutting height can be varied from MIN (5 cm /2 in.) to MAX (9 cm / 3.6 in.).CAUTION: During the first weeks aftera new installation, the cutting heightmust be set to MAX to avoid damagingthe loop wire. After this, the cuttingheight can be lowered step by stepevery week until the desired cuttingheight has been reached.4.7.1 To adjust the cutting height1. Press the STOP button to stop the product.2. Open the hatch.OK65783. Turn the knob to the required position.• Turn clockwise to increase the cuttingheight.• Turn counter-clockwise to decrease thecutting height.4. Close the hatch.28 - Operation 982 - 001 - 12.12.2018