Husqvarna 115H Operator's Manual

Also see for 115H: Workshop manual

Max +/- 2 cm / 0.8 in.• Put the charging station in the lowestpossible section of the work area.• Put the charging station in an area withprotection from the sun.• If the charging station is installed on anisland, make sure to connect the guide wireto the island. Refer toTo make an island onpage 16.3.3.2 To examine where to put the powersupply• Put the power supply in an area with a roofand protection from the sun and rain.• Put the power supply in an area with goodairflow.• Use a residual-current device (RCD) whenyou connect the power supply to the poweroutlet.WARNING: Do not change the powersupply. Do not cut or extend the low-voltage cable. There is a risk ofelectrical shock.Low-voltage cables of different lengths areavailable as accessories.CAUTION: Make sure that the bladeson the product do not cut the low-voltage cable.CAUTION: Do not put the low-voltagecable in a coil or below the chargingstation plate. The coil causesinterference with the signal from thecharging station.3.3.3 To examine where to put theboundary wireCAUTION: If the work area is adjacentto water bodies, slopes, precipices or apublic road, the boundary wire musthave a protective wall. The wall mustbe minimum 15 cm / 6 in. in height.DEBCFA• Put the boundary wire around all of the workarea (A). Adapt the distance between theboundary wire and obstacles.• Put the boundary wire 35 cm / 14 in. (B)from an obstacle that is more than 5 cm / 2in. high.• Put the boundary wire 30 cm / 12 in. (C)from an obstacle that is 1-5 cm / 0.4-2 in.high.• Put the boundary wire 10 cm / 4 in. (D) froman obstacle that is less than 1 cm / 0.4 in.982 - 001 - 12.12.2018 Installation - 15