Husqvarna 1-8DPS30 Operator's Manual

Also see for 1-8DPS30: Operator's manual

WARNING: Use protective boots withsteel toe-cap and non-slip sole.WARNING: Do not move the productup and down ramps manually with the drivesystem disengaged. Only move the productmanually on level ground.1. Disengage the drive system. Refer toTo engage thedrive system on page 10.2. Push the handle downwards.3. Push or pull the product by the handle.4. Engage the drive system. Refer toTo engage thedrive system on page 10. With the motor off, thishas the function of a parking brake and preventsaccidental movement of the product.To move the product with the drivesystemWARNING: The product is heavy andthere is a risk of injury if the product falls. Becareful when you move around the product.WARNING: Do not lift the product ofthe ground during operation.WARNING: Do not move the productforward during operation.WARNING: Use protective boots withsteel toe-cap and non-slip sole.1. Engage the drive system. Refer toTo engage thedrive system on page 10.2. Pull down the handle to lift the product from thesurface.3. Set and adjust the movement speed with the speedcontrol dial (C).A B CD4. Push and hold the drive system lever (D) to movethe product rearward.5. Push and hold the overdrive button (A) to move atmaximum speed.6. Push and hold the forward button (B) to move theproduct forward.To move the product up and down arampWARNING: Be very careful when youmove the product up and down ramps. Theproduct is heavy and there is a risk of injuryif the product falls or moves too quickly.WARNING: For ramps with a steepslope, always use a winch. Do not walk orstay below or near the product.• To move the product down a ramp, operate theproduct forward slowly.• To move the product up a ramp, operate the productrearward slowly.• Do not turn the product to the left or to the right morethan 45° on a ramp.2087 - 002 - 05.04.2023 25