Honeywell VISTA-128BPT User Manual

Also see for VISTA-128BPT: User guide Overview Programming guide Installation and setup guide Installation and setup guide

Contents

Honeywell VISTA-128BPT User Manual Manual pdf 61 page image

55Event Log Procedures (cont’d)4. Scroll through the categories.Use the [3] & [1] keys (for next and previous categories respectively) to display thecategories of events.Press [8] to select a category and display the first event. Press [8] again for eachsubsequent event.Example: Shows burglary alarm occurred in zone 3 (C003) of partition 1 (P1), at 12:02AMon January 1.P1 01/01 12:02AMBURGLARY C003Typical Event Log DisplayAfter the last event has been displayed, the END OF EVENT LOG message appears for afew seconds, then the system automatically displays the RECENT/COMPLETE mode selectscreen again (see step 2).5. To EXIT the Event Log Press [∗] at any time.ALARM EVENT LOGTYPE CCC UUUALARM EVENT LOGDisplays time and date for zones that has either caused an alarm or has been restored in theselected partition.CHECK EVENT LOGDisplays time and date for zones that has caused a trouble or supervisory condition in theselected partition.BYPASS EVENT LOGDisplays time and date for zones that has been bypassed in the partition.OPEN EVENT LOGDisplays time, date and user number or 6-character descriptor for the user, if programmed,for each arming and disarming of the system for the partition selected.SYSTEM EVENT LOGDisplays time and date for system problems, such as AC Loss, low battery, etc., regardless ofpartition.ALL EVENT LOGDisplays all categories of events in chronological order.6. See your Installer for additional information concerning the event log.