Honeywell VISTA-128BPT User Manual

Also see for VISTA-128BPT: User guide Overview Programming guide Installation and setup guide Installation and setup guide

Contents

Honeywell VISTA-128BPT User Manual Manual pdf 43 page image

37Section 19: Using the Keyswitch• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •G e n e r a lYour system may be equipped with a keyswitch for use when arming and disarming a partition. A redand green light on the keyswitch plate indicate the status of your system as follows:Green Light: Lights when the system is disarmed and ready to be armed (no openzones). If the system is disarmed and the green light is off, it indicatesthe system is not ready (one or more zones are open).Red Light: Lights when system is armed or memory of alarm exists.MessagesLit Steady: Partition is armed in AWAY mode.Slow Flashing: Partition is armed in STAY mode.Rapid Flashing: Memory of alarm, indicating an alarm has occurred.ArmingArming AWAY: Turn the key to the right for 1 second and release. Keypads will beeptwice and the red light will stay on steady.Arming STAY: Turn the key to the right and hold for longer than 10 seconds, thenrelease. Keypads will beep three times and the red light will flash slowly.DisarmingTurn the key to the right and release. If an alarm has occurred, the red light will be flashing rapidly(memory of alarm).