6 UNSETTING THE SYSTEMNormal EntryUnsetting starts immediately when the FINAL door is opened or anENTRY zone is activated. The sounder pulses slowly and the user mustgo directly to the keypad and enter a valid PIN, followed by A>, orent. Users with group choice, will access the UNSET screen followingPIN entry. This permits the user to unset specific groups. To return tothe SET screen press ent.Straying From the Entry RouteGo directly to the keypad when entering the building. If the user straysinto a protected area and activates a zone, a full alarm will occur. Thepolice may be called out and the system will have to be reset.Slow EntryEnter a valid PIN before the entry time expires. If the entry time expiresbefore a valid PIN is entered, then a full alarm will occur. The sounderbegins to pulse quickly when 75% of the entry time has elapsedindicating time is running short.Cancelling AlarmsTo cancel an alarm, enter a valid PIN followed by ent at the keypad. Thekeypad displays details of the zone activated. When more than one zoneis activated, details can be viewed using A > or < B. Press ent to returnto the banner. Certain types of alarms, once cancelled, require a codewith the appropriate reset authorisation to be entered. The systemprompts for a valid reset code by displaying Manager Reset Re-quired or Engineer Reset Required on the keypad.Manager ResetEntering a manager level PIN followed by ent, resets the system followingan alarm activation.Engineer ResetCertain types of alarm require an engineer to visit the site and, afterinvestigation, reset the system. In such cases, the system cannot be resetuntil the engineer reset has been carried out.Unsetting with the MicroMAX CardsIf any of the groups assigned to the MicroMAX are set, then swipingthe MicroMAX module with a card unsets the groups. Group choiceand dual focus operation, where implemented will apply as per settinginstructions.
