Honeywell F-BO-AFE70 Series Installation, Connection, Commissioning, Maintenance

Contents

Honeywell F-BO-AFE70 Series Installation, Connection, Commissioning, Maintenance Manual pdf 33 page image

User Manual Series F-BO-AFE70 Chapter 9 • Connection and parameterisation9.4.1 Standard connection with indirect actuation through the fire detection control panel (inaccordance with EN 54-13)Fig. 12: Standard connection of the Automatic Purging Unit F-BO-AFE70 to the FDCP and to an ASD,via a monitored line. All components are only shown as schematic diagram, with the exception ofthe Purging unit.A … Aspirating smoke detector (in order to provide a clearer overview, only the connections thatare absolutely necessary for the Purging unit are shown)The two relay contacts are shown in the state where no voltage is being provided to therelays.B … Power unit (observe the country-specific regulations for the power supply of aspiratingsmoke detectors and special detectors)C … Fire alarm message to the fire detection control panel (observe the connection conditionsfor the fire detection control panel used)D … Fault message to the fire detection control panel (observe the connection conditions for thefire detection control panel used)E … Actuation output on the fire detection control panel (observe the connection conditions forthe fire detection control panel used)This output is used to start the Purging processes if the ASD experiences a fault.Manual Purging activations can be carried out by manipulating operating devices that areintended for this purpose, provided that this feature has been prepared by the installer of thesystem.F … In addition, the fault output of the F-BO-AFE70 can optionally be connected to the firedetection control panel in order to transmit the fault of the AFE70 itself (through wirebreakage of this fault detector line).9.4.1.1 Output „Slave activation“This dry output is used if one or more „slave“ unit(s) F-BO-AFE70 is/are to be actuated by the„master“ unit F-BO-AFE70. The „slave“ units start virtually at the same time as the master unit. Ifa device number has been set on the master unit, it will be evaluated, a device number that has beenset on a slave unit will have no effect.I56-4252-010D200-104-0033