Honeywell Domonial User Manual

Also see for Domonial: User manual Technical specifications User manual User manual User manual

Contents

Honeywell Domonial User Manual Manual pdf 10 page image

To reset the system follow the disarming procedures using either your code or keytag four timesconsecutively. Ensure the audible disarm tone sounds after each disarming procedure.If the two red LEDs are illuminated on your alarm panel, this indicates a confirmedalarm has occured and a remote reset is required and the system will not operate. To remotely resetyour system call your Service Department : CHANGING OR SETTING ADDITIONAL CODESTo change or set additional user codes firstly enter programming mode✔ Press key : simultaneously✔ The red light will flash slowly✔ Enter the 4 digit master code (user 1)✔ Select and enter an existing or new single digit user ID (0-9)(N.B. : User 1 is always the master)✔ Enter the new 4 digit code for this user✔ A double beep on the keypad will confirm acceptance of the new code.✔ You must confirm the new code by re entering the 4 digits numbers.✔ A double beep on the keypad will confirm acceptance of the new code.Exit programming mode by pressing key. CHANGING OR SETTING ADDITIONAL KEY TAGA key TAG can only be programmed to an existing user’s 4 digits code.To change or set additional key TAG firstly enter programming mode✔ Press key : simultaneously✔ The red light will flash slowly+01 2 34 5 68 97SOS10+