Harman Allure50 Owner's Manual

Also see for Allure50: Owner's manual Installation manual

Contents

Harman Allure50 Owner's Manual Manual pdf 24 page image

Harman® • Allure50 Owner’s Manual_R3 • 2016 -___ • 09/16243-90-888000cStep 1 - Installing Side Panels: Locate the cut-outs in thetop of the panel that marry to the hooks located underneaththe cast top. Once in place simply place the bottom of thepanel flush against unit. Figure 1.Step 2: Tighten the (4) 10-24 x 1/2” Thread cutting screwusing a 5/16” nut driver, (2) Thread cutting screws per panel.Figure 2. (Note: The door does not need to be removedto access screws.)Helpful Hint; When tightening the right panel front screw,open the door slowly until it contacts the side panel. Thiswill push the side panel fully into the slot for tightening fromthe front.Figure 1Step 4 - Installing columns with no glass: Door mustbe slightly open. Insert right column from the side. Whileholding column to the door swing door open and install (3)10-24 x 3/8” Button Head Screws at the top, center andbottom of the door. Figure 4. Repeat step for other side.Note: Use 1/8” Allen Wrench supplied with stove.Top of doorFigure 4Figure 2Front sideBack sideStep 3 - Installing glass: If glass is not being installedmove onto step 4. Install right side column, do not tightenscrews. Prior to installing glass make sure the end marked“Top” is up. Slide glass behind right hand column and pushglass flush with door and center glass. Figure 3. Install theleft column and tighten (3) 10-24 x 3/8” Button Head Screwsat the top, center and bottom of the door, tighten right sidecolumn. Figure 4. Note: Use 1/8” Allen Wrench suppliedwith stove.Figure 3Slide glassbehind columnF. Glass Installation and Cleaning

/ 26

Related manuals for Harman Allure50