Hangar 9 Tango 40 ARF Assembly Manual

Contents

Hangar 9 Tango 40 ARF Assembly Manual Manual pdf 20 page image

20Required Parts• Fuselage • Wing• Canopy • Hook and loop strap• 1/4-20 x 2-inch nylon bolt (2)Required Tools and Adhesives• Canopy glue • Flat screwdriver• Masking tape • 1/4-inch foam• Hobby knife • Receiver• Receiver battery • Switch harness Step 1Wrap the receiver and receiver battery in 1/4-inch foam toprotect them from vibration. Step 2Plug the throttle, elevator and rudder servo leads, as wellas the switch harness, into the receiver. Route the receiverantenna to the rear of the fuselage. A tube has been pre-installed for routing the receiver antenna wire. Step 3Place the receiver (both electric and glow) into thefuselage on the top of the plywood tray. Use a hook andloop strap to secure the battery to the tray as shown.Note: When using an electric motorand a receiver pack, place the packunderneath the receiver to providemore room for the motor batteries.Note: In glow applications, the receiverbattery is placed on the bottom side of theplywood tray, and the strap will go aroundboth the receiver and receiver battery. Step 4Mount the switch harness in the side of the fuselage. Theswitch should be on the opposite side of the muffler whenusing a glow engine.Section 4: Final Assembly