Haier XQSB60-JN User Manual

Also see for XQSB60-JN: User manual

Contents

Haier XQSB60-JN User Manual Manual pdf 8 page image

6Install the water inlet hoseThe exit end face of the faucetConfirm the water faucetConnection between the water inlet hose jointer and the water faucetwater faucet, suitable water faucet, not suitableIt is required that the front end shall be longer than 10mm.The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage.2 Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet.See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosenthe four screws and take out the bushing in the jointer. The front end of the faucet must be smooth,otherwise it may leak water. See to Figure 3.)1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from thewater inlet hose component. See to Figure 1.3.Fasten the four screws evenly. See to Figure 4.remark: Before installation, the threading is 4mm above the upper surface of the nut.After installation, the threading is 2mm above the upper surface of the nut..water inlet hose jointerScrew knifewater inlet hoseFigure 1Figure 4 Figure 5SliderLock lever4 Take off the nameplate. Twist the fastening nut as per the indication of the figureto seal up the exit end face of the faucet. See to Figure 5.About 4mm before twistingAbout less than 2mm after twistingScrewBushingSign plateScrew nutFigure 2 Figure 3Figure 6