SETUPDVD System SetupDVD System SetupGeneral Setup Process1.Press the SETUP button, theGeneral Setup Page,PreferencePage will be displayed in turn.2.Press CH+/- b to select, theitem, then press to enter thesubmenu.3.Press CH+/- bu to select thenpress PLAY/ENTER to confirm.4.Press EXIT key or press SETUPrepeatedly to exit the set-upmenus.ororGeneral Setup PageWhen using the DVD with the internal TV,select .4 3/LBThe following information applies onlywhen the DVD output is connected to anexternal TV.(PS = Pan and Scan)You may select this if you have a normalaspect ratio (4:3) TV, although the NORMAL/LB (letter box) is a more common choice. InPS mode, widescreen material will fill the screen, but at the expense ofchopping off extreme left and right edges of the original film picture. For thisfeature to work, the disc must be specially coded. Such discs are uncommon.(LB = Letter Box)You may select this if you have a normal aspect ratio (4:3) TV. Widescreenmaterial will be shown in pure unaltered form, allowing the entire picture areaof the original film to be viewed without any side cropping. Black bars willappear above and below the picture.You may select this if you have a widescreen (16:9) TV. Back bars may stillappear above and below the picture even if using a widescreen TV. This isbecause some film directors prefer to use ultra widescreen aspect ratios e.g.2.35:1. This will normally be indicated on the DVD packaging.4 3/PS4 3/LB16 9ASPECT RATIO DESCRIPTION..General Setup Page..Tv Display 4:3 LBAngle Mark OnOsd Lang ENGCaption OnScreen Saver Off4 3/Ps4 3/Lb16 9..PALAUTONTSC..Preference Page..TV TypeParentalPasswordDefaultAuto..General Setup Page..4 3/Ps4 3/Lb16 9..TV Display 4:3 LBAngle Mark OnOSD Lang ENGCaption OnScreen Saver OffPLAY/ENTERSETUPPLAY/ENTER