Haier HNDE03 User Manual

Also see for HNDE03: Energy guide

Haier HNDE03 User Manual Manual pdf 7 page image

Installation Limitations• Do not install your refrigerator in any location not properly insulated or heated,e.g. garage, etc. Your refrigerator was not designed to operate in temperaturesettings below 55˚ Fahrenheit.• Select a suitable location for the refrigerator on a hard even surface awayfrom direct sunlight or heat source, e.g. radiators, baseboard heaters, cookingappliances, etc. Any floor unevenness should be corrected with the leveling legslocated on the front bottom corners of the refrigerator.Door AlignmentFreezer Door: (see fig. #1)1. Remove the top hinge cover.2. Loosen the top hinge screws using a phillips head screwdriver.3. Adjust the door or put a spacer in between and then tighten the screws.4. Replace the top hinge cover.Reversing the Door (See Fig. #4)1. Remove the top hinge cover. (See Fig. #1)2. Using Phillips Head Screwdriver, loosen and remove thescrews holding the top hinge in place.3. Remove top hinge and carefully lift off thefreezer door.4. Remove the screw hole plugs from theopposite side and insert the plugs in thescrew hole openings of the just removedscrews.5. Open refrigerator Door and unscrew 2 screws from the center hinge bracketwhile holding the open door in place. (See Fig. #2)6. Remove bracket and lift off refrigerator door7. While doors are removed unscrew the door stoppers and reinsert on oppositeside of door. (See Fig. #3)8. Remove the screw hole plugs from the opposite side and insert the plugs in thescrew hole openings of the just removed screws.9. Remove any loose items in the refrigerator andcarefully tilt refrigerator and lean against wall.Remove both leveling legs and place in a securearea.10. Loosen the screws holding the lower hinge bracketto the refrigerator door and remove screws andbracket. Remove leveling leg102345675EnglishFig. #1Fig. #2