Haier HBF05E Installation Instructions Manual

Also see for HBF05E: Manual User manual

Contents

Haier HBF05E Installation Instructions Manual Manual pdf 9 page image

8EnglishInstalling the GuardrailFollow the steps below to install the guardrail onthe worktop.1. Place the guardrail on top of the cabinet.2. Align all holes of the guardrail with the holesof the cabinet.3. Secure the guardrail to the cabinet with eightsmall Phillips-Head screws.Installing the CO2 Regulator and CO 2 CylinderFollow the steps below to safely install the CO2 regulator and CO2 cylinder. Youmust read and understand the following procedures for CO2 cylinders beforeinstallation.Note: Your CO 2 cylinder is shipped empty to avoid any possible accidents duringtransportation. When you purchase the first keg of beer, have your beerdistributor fill the CO2 cylinder.1. Install the CO2 air line hose to the regulator by attaching one end of the red airline hose to the hose barb connection on theCO 2 regulator. Secure the hose by using oneof the two self-locking black plastic snap-onclamps. Use pliers to snap the clamp ontightly to ensure that there are no leaks.2. Attach the CO2 regulator to the CO2cylinder by screwing the regulator nut ontothe cylinder valve and tightening with anadjustable wrench.3. Remove the nut from the retainer bolt.Use two retainer fixing screws to secure theretainer to the holes on the back of thecylinder.4. Slide the cylinder through the retainer andplace it in the cabinet. Then tighten theretainer nut.WARNING!CO2 can be dangerous! CO 2 cylinders contain high-pressured gas, whichcan be hazardous if handled improperly. They must be handled with care.CO2 CylinderCO2GASCO 2RegulatorConnect to the CO 2Air LineClampShut-OffValveRetainerConnect to the CO 2 Cylinder