Haier HBF05E Installation Instructions Manual

Also see for HBF05E: Manual User manual

Contents

Haier HBF05E Installation Instructions Manual Manual pdf 5 page image

4English1. Remove all packing materials. This includes the foam base and all adhesivetape holding the accessories both inside and outside. Slide out and remove theplastic or foam guard used to secure the compressor during shipping.2. Inspect and remove any remaining packaging, tape or printed materials beforeturning on the beer dispenser.Note: Allow the beer dispenser to stand in an upright position for 2 hours beforeturning on the power.Check all supplied accessories in the carton to be sure that all pieces are presentand in good condition. A checklist of accessories is listed below for your reference.If you find any accessories that are not in good condition or are missing, pleasecontact our customer service department for assistance. Our Toll-Free numberis 1-877-337-3639.1 Beer Tap Including:1 Gasket for the Beer Tap1 Washer for Connection to the Keg Coupler1 CO 2 Regulator1 CO 2 Cylinder1 Keg Coupler1 Cleaning Kit1 CO 2 Air Line2 Hose Clamps1 CO 2 Cylinder Retainer1 Guardrail1 Drip Tray4 Casters1 Wrench4 Large Phillips-Head Screws8 Small Phillips-Head Screws2 Retainer Fixing Screws2 Wire Shelves4 Support PinsUnpacking and Accessories Inventory