Haier AWT-80LI User Manual

Contents

Haier AWT-80LI User Manual Manual pdf 6 page image

Midway spinningPushPushProper ProperOuter cover ofthe spin tubInner cover ofthe spin tubThe laundriesare slantingGlandNo gland1.Put the laundries into the spin tub evenly and smoothly.2.Spin(1) Put the gland in properly.Please put in the gland properly even if the laundries quantity is small.(2) Close the inner and outer cover of the spin tub.(3) Spin for 1-2 minutes.93.Run the foam-removing spinning.12Set the inlet selector handle on spin side andfill water for about 1 min.Close the spin tub outer cover and spinfor about 1 - 2 min.In case water flows out from wash tub sidedue to too much inflow, please turn downthe water tap a bit.Wash SpinWater inletInlet selector handle4Installation and adjustmentPlease install and adjust the machine according to the requirement ofthe manual. It is very important to your security and correct operatingthe machine.Usage of the drain hoseIf the extra hose is too long, cut it eitherat point A or B.<10cmBA> 30mm<1.5mThe drainage shall be smooth with the drain hose.1.The height of the drain hose shall beless than 10cm , or the drainage willnot be smooth enough and causeincomplete drainage.2.Do not tramp or press the drain hose.3.If the drain hose is too long, cut it at mid point.To make smooth drainage, cut the front end ofthe hose slantingly.4.If extra drain hose is needed , please makeseparate purchase. The inner diameter of theextra hose shall not less than 30mm, and thelength shall not exceed 1.5m.Overflow filterLint filterInstall the lint filterAfter opening the package,please take out the lintfilter from the document bag,install it to the overflowfilter of the wash tub.See to the figure.

/ 8

Related manuals for Haier AWT-80LI