Haier AWCE26ARS User Manual

Contents

Haier AWCE26ARS User Manual Manual pdf 11 page image

9EnglishDoor Reversal1. Using a Phillips screw driver remove the upper hinge bracket by removing the screws and the hingecover on the bracket. (on the right side).2. Lift and remove the door.3. Remove the bottom hinge bracket by removing the 3 hexagonal nuts. Be careful not to loose the doorlevel rings which are placed in the hinge bracket axle. (right side).4. Remove the lower door as shown in figure and install on opposite side.5. To install the bottom hinge bracket on the opposite side (left side), you will also have to remove screwhole plug from the left side.6. Carefully align the bottom hinge axle hole on the door with the axle of the lower hinge bracket.Remember to have the door level rings in place before you place the door on its axle.7. Install the upper hinge bracket on the left side.8. Make sure the door is aligned and then tighten the screws.9. Remove and reinstall the door handle on the opposite side.Replacing Light Bulb1. Turn off and unplug the power cord of the wine cellar.2. To remove the light bulb cover use a Phillips screw driver to remove the 3 screws.3. Make sure the light bulb is cool before removing it. Replace using a light bulb 10 watts or less.4. After the bulb is secure, install the light bulb cover and replace the three screws.5. Turn unit on to its original setting after plugging in the power cord.