Connecting the Device to the Electricity Supply The device must be connected to a properly earthed socket in line withthe relevant valid country regulations. Check prior to initial operation that the voltagenoted on the model label corresponds to themains voltage.If this is not the case, do not connect thedevice and contact your dealer!If the connection cable is damaged it must be replaced by theCustomer Service at Dometic, or by respectively qualified personnel,in order to prevent any hazards.Attention: For GB Only !Plug connection (for United Kingdom only)If a 3-pin plug is used, it should be fitted with a 3 amp fuse,with other plug types, the circuit should contain a 5 amp fuse.Warning - This appliance must be earthed.IMPORTANTThe wires in the mains lead of this applianceare coloured in accordance with the followingcode:GREEN and YELLOW : EARTHBLUE : NEUTRALBROWN : LIVEAs the colours of the wires in the mains leadmay not correspond with the coloured markingsidentifying the terminals in your plug, proceed asfollows.1. Connect the GREEN and YELLOW coloured wire to the plug terminalmarked letter E or earth symbol or coloured green or green and yellow.2. Connect the BROWN coloured wire to the plug terminal marked letter Lor coloured red.3. Connect the BLUE coloured wire to the plug terminal marked letter N orcoloured black.Moulded-On Plug VersionThe mains lead is fitted with a non-rewirable moulded-on plug con-taining a 3 amp fuse. If the fuse requires replacing at any time, the fusecover/carrier should be removed using a small screwdriver to level out. Theold fuse should be replaced by a 3 amp ASTA approved BS1362 fuse andthe fuse cover/carrier must be refitted before the plug is used again.If the fuse cover-carrier is lost, a replaceement can be obtained from theDometic service Shops.The fuse cover/carrier must be of the same colour as that of the colouredinsert in the base of the plug. In no circumstances must the plug be usedwithout a correct fuse cover/carrier fitted. ......4.774.7.1