Hafele 533.03.560 User Manual

Contents

Hafele 533.03.560 User Manual Manual pdf 13 page image

EN - 134. USE OF PRODUCT4.1. Hob ControlsThe appliance is operated by pressingbuttons, confirmed by displays and audiblesounds.15 6 7 82 3 41- Heater display2- Activate/Deactivate heater3- Heat setting increase4- Key lock5- Decimal point6- Heat setting decrease7- On/Off8- Key lock indicatorMode DescriptionsStand-By-Mode S-ModeThe mains is applied to thehob control and all heaterdisplays are off or a residualheat display is active.Operating-Mode B-Mode At least one heater displayshows a heat settingbetween ´0` and ´9`.Lock Mode VR-Mode The hob control is locked.Switching the Appliance On and OffIf the appliance is in Stand-By mode, itis put in Operating mode by pressing theOn/Off button for at least 1 second. Abuzzer will sound to indicate the successfuloperation.A “0” will appear on all heater displays andall decimal points corresponding to theheaters will flash (1 second on, 1 secondoff).If there is no operation within 10 seconds,the display on all heaters will switch off.If the displays do switch off, the heater willbe sent into Stand-By mode.If is pressed for more than 2 seconds(in Operating mode), the appliance willswitch off and will enter S-Mode again. Theappliance can be switched off by pressingat any time; even if other buttons arepressed simultaneously.If there is any residual heat from a heater,this will be indicated in the correspondingHeater Display with a “H”.Selecting a HeaterIf a single heater is chosen with thecorresponding Activate/Deactivate HeaterButton , the decimal point of the HeaterDisplay will flash. For the selected heater,the heat level can be set between 1 and 9by pressing the Heat Setting Buttons or.The buttons must be pressed within 3seconds of selecting a heater, otherwisethe heater selection is erased and the heatsetting decimal point will disappear. If thereis no further operation within 10 seconds,the heater reverts back to S-Mode.The heat setting can always be changed bypressing or . The available settingsare between 1 and 9.Each button operation or each displaychange will be accompanied by a buzzersound.Set Cooking Level with and without HeatBoostAll heaters are equipped with the heatboost function.If the heat boost is required, set the heatfrom the current level to level 9 by pressingthe button only. Once level 9 has beenreached, press to activate the heatboost. The display will flash “A” alternatingwith the heat setting value “9” to show theheat boost is active.If the heat boost is active, the heater willoperate with maximum power for a period oftime dependent on the heat setting selectedbefore the heat boost was activated.Once the heat boost time has ended, onlythe heat setting will be indicated on theheater display.The heat boost can be deactivated bypressing until the heat setting “0” isdisplayed.Switching Off Individual HeatersA heater can be switched off in 3 differentways:• Simultaneous pressing of andbuttons• Reduction of the heat setting to “0” bypressing the button• Use of the timer switch-off function for