Hach TitraLab AT1102 User Manual

Also see for TitraLab AT1000 Series: Basic user manual Basic user manual

Contents

Hach TitraLab AT1102 User Manual Manual pdf 13 page image

Section 3 InstallationC A U T I O NMultiple hazards. Only qualified personnel must conduct the tasks described in thissection of the document.N O T I C EThis is a class A product. There may be potential difficulties in ensuring electromagneticcompatibility in other environments, due to conducted as well as radiated disturbances. In adomestic environment this product may cause radio interference in which case the user may berequired to take adequate measures.N O T I C ENetwork and access point security is the responsibility of the customer that uses the wirelessinstrument. The manufacturer will not be liable for any damages, inclusive however not limited toindirect, special, consequential or incidental damages, that have been caused by a gap in, orbreach of network security.The instrument is available in different configurations (refer to Table 2 on page 8). Thismanual supplies instructions for the installation of an instrument with one syringe and onepump. Adjust the installation procedure as applicable to accommodate the number ofsyringes and pumps in the instrument.3.1 Installation guidelines• This instrument is for indoor use only.• The power supply connector on the rear panel must be easily accessible so thepower can be disconnected quickly in case of emergency.• Keep the instrument away from temperature extremes, including heaters, directsunlight and other heat sources.• Put the instrument on a stable and level surface in a well ventilated place.• Make sure that there is at least 15 cm (6 in.) of space on all sides of the instrument toprevent electrical parts from overheating.• Do not operate or keep the instrument in dusty, damp or wet locations.• Always keep the surface of the instrument and all accessories dry and clean.3.2 Connect to AC powerD A N G E RElectrocution hazard. If this equipment is used outdoors or in potentially wet locations, aGround Fault Circuit Interrupt (GFCI/GFI) device must be used for connecting theequipment to its main power source.C A U T I O NElectrical shock and fire hazards. Make sure that the supplied cord and non‐locking plugmeet the applicable country code requirements.W A R N I N GFire hazard. Use only the external power supply that is specified for this instrument.11