Section 3Page 2951350-18 Initial Aquatrend Setup.fm Network Setup3.4.3.2 Replacing a Device on the NetworkBefore beginning the replace device procedure, the new device must bephysically attached (wired) to the network and powered. Refer to theinstallation section in the device manual for information.1. Press the MENU key to access the Main Menu.2. Use the up or down arrow key to move the pointer to Network Menu andpress ENTER.3. Select REPLACE DEVICE and press the ENTER key. A list of devices toreplace will appear.4. Select the type of device to replace and press ENTER.5. Select the device to replace (if more than one device is available forreplacement) and press ENTER. Or, press the configure button on thedevice you want to replace (press the ENTER key on a remote AquaTrendInterface). If only one device to replace is available, it will be selectedautomatically.6. A pop-up box will appear showing the device to be replaced. If it iscorrect, choose REPLACE DEVICE.7. A warning pop-up box will appear. Select CONTINUE and press theENTER to continue with the replacement.8. A search for available replacement devices will begin. If more than one isfound, press the configure button on the replacement device (press theENTER key on a remote AquaTrend Interface).9. When the replace procedure is complete, a status screen appears. Pressthe ENTER key to acknowledge and continue normal operations.10. Now that the device has been replaced you must verify and/or replace alldevice specific settings.
